User's Manual

status of the remote control function (including the relay output) to avoid
inconsistent wiring.
二十九、 5. The receiver should not be installed in the electric control box.
The correct installation method is to fix the receiver to the top of the electric
control box (or external), and then insert the receiver output cable into the
electric control box to make appropriate. wiring.
三十、 6. This series of remote control has 4 billion sets of security codes.
The security code settings are different at the factory. It is necessary to confirm
whether there is a remote control with the same security code in the same working
area during installation to avoid mutual influence and cause wrong action.
三十一、 Second, the handling of emergency
三十二、 When an emergency occurs, please follow the steps below and notify the
dealer immediately.
三十三、 1. Press the transmitter emergency stop button (or emergency stop
button)
三十四、 2. Remove the transmitter's key switch (E2S turns the rotary key switch
to the "off" position and removes it; E2B removes the key switch; E2M removes the
battery cover). Turn off the overhead power of the crane.
三十五、 3. Notify the dealer to find out why.
Instructions
F21-E2B series remote control configuration
Normal operation
1. Insert the fully charged AA (size 5) battery into the battery compartment
of the transmitter in the correct direction (note: the battery release strip of the
E2S transmitter should be placed under the battery), and the battery cover is indeed
locked. .
2. Place the transmitter key switch in the "on" position (Note: E2B places the