User's Guide

You can add Moisture Sensor (not included) to pair
with your Bluetooth® Timer.
The moisture sensor can be used to reduce your
water use. Pairing can only be done with one zone at
a time.
First, obtain 2 fresh AAA alkaline batteries and insert
them into the battery tray of the sensor. Once they are
inserted, press the yellow button on your sensor for
about 5 seconds to start the pairing with the timer.
Press the co-ordinating zone button on your timer for 5
seconds. You will notice on your timer that the sensor
has been paired. The indicator light will flash blue.
Repeat this step for every sensor you want to add for
the rest of valves.
Then place the sensor into the soil at the location you
want to monitor the moisture from. The sensor will
show the moisture levels after a few minutes have
expired.
Additional sensors can be added for multi zoned
timers using the same above instructions.
User’s Guide
Bluetooth® Moisture Sensor Pairing :