User guide

PC6000 Menus Section 4
YSI Incorporated PC6000 Software Operations Manual 19
Sensor Type Minimum Maximum Mean Std.Dev.
Temperature (C) 4.69 21.00 5.88 2.877
Conductivity (mS/cm) 0.01 29.94 0.41 1.934
pH 6.32 9.44 7.64 0.200
ORP (mV) 75.7 313.5 156.7 36.45
DO (mg/L) 6.12 14.97 6.70 0.696
Number of samples = 1305
To print a copy of the Statistics screen, press the F2 key.
4.1.3 SYSTEM
SYSTEM
menu options allow you to print the report and plot the data, or export the data to another
software program. The specific setup format of the report or plot can also be frozen for future use.
Filename: SAMPLE.DAT
MODIFY VIEW SYSTEM
Parameters... Header Print Report
Control Info... Report Print Plot
Scaling Info... Plot Definitions...
Statistics Export
Select the
Print Report
option to send your report to the printer. After you select this option, a
prompt appears on the screen asking if your printer is ready. Press
Enter
to proceed with the print
operation. If more than 8 parameters are to be printed, PC6000 will assume you have a
wide-carriage printer. If your printer is not wide-carriage, set your printer to compress mode before
printing (see your printer manual for instructions). The printer port option, in the setup menu,
specifies the computer port to which the report will be sent.
Select the
Print Plot
option to send your plot to the printer. After you select this option, a prompt
appears on the screen asking if your printer is ready. Press
Enter
to proceed with the print
operation. The printer port option, in the setup menu, specifies the computer port to which the plot
will be sent.
Select
Definitions
to create and save different report or plot configurations from the same data file.
Each file contains all options and setup information you defined in the Modify menus, see the
MODIFY options section, described earlier. After you have selected Definitions from the
SYSTEM menu.