User manual

Relay outputs System 182-XT-4
6 - 4
ba76027e02 12/2014
6.2.3 Setting outputs
Procedure:
Setting an output
1 Open the SETTINGS menu with s.
2 Using
w and g, select and confirm the Relay output Rx
menu item (corresponding to sensor 1, 2 or 3).
3 Confirm the selection Set output with g.
The setting table of the output is displayed.
4 Edit the setting table as described in section 4.3.2.
To accept all settings, highlight the
Save and quit menu item at the lower end of the setting
table and press
g. If you exit the setting table via m, e/
Quit or the Quit menu item, all changes are ignored.