User manual

The SETTINGS menu System 182-XT-4
5 - 4
ba76027e02 12/2014
options are described in detail in the chapter 6 RELAY OUTPUTS menu.
5.5 PROFIBUS config.
You can set the PROFIBUS address in this menu (see operating
manual "IQ S
ENSORNET Field bus linking").
5.6 System
The settings in the SYSTEM menu comprise:
 Date/Time
 Pressure/Altitude
This setting is important if you want to carry out D. O. measurements
with the System 182.
(adjustable range: 500 ... 1100 mbar or 0 ... 5955 m altitude).
 Settings
a / z?
Here you can configure the password for the settings.
For details on the passwords, refer to section 4.6.
 Calibrate
a / z?
Here you can configure the password for calibration.
For details on the passwords, refer to section 4.6.
 Display contrast
Here you can set the display contrast for optimum readability.
 Delivery state
Here you can reset all settings to the default values. Only the date,
time and contrast setting for the display will remain stored. If the
settings password is active, a password prompt appears before the
reset. In any case a security prompt appears to prevent an
inadvertent reset.
Delivery condition
Settings
Language English
Pressure/Altitude 1013 mbar / 0 m
Settings password 1000 / inactive
Calibration password 1000 / inactive