User manual

System 182-XT-4 Installation

3 - 27

ba76027e02 12/2014

Fig. 3-20 Mounting DIQ/S 182 Universal Transmitter in switch panel

3 Slightly unscrew the screws (pos. 2 and 3) of the two angle

brackets (pos. 1 in Fig. 3-20), but do not remove them.

4 Push in the two angle brackets - as shown in Fig. 3-20 - into

the lateral guides of the Universal Transmitter up to the stop.

5 Tighten the screws (pos. 2).

6 Screw in the screws (pos. 3) until the screws rest snugly

against the panel.

7 Screw the DIQ/CR3 combi output module onto the DIQ/S 182

Universal Transmitter.

For stack mounting remove label

and install contact carrier