User manual

System 182-XT-4 Installation
3 - 13
ba76027e02 12/2014
Fig. 3-6 Closing the enclosure (variant 1)
3.4.3 Variant 2: stack expansion backwards
Preparing the stack
mounting
Fig. 3-7 Preparing the MIQ modules for stack mounting (variant 2)
7 Attach the prepared DIQ/S 182-XT-4-PR to the cover of the
MIQ module. At the same time, ensure that the two clips on the
DIQ/S 182-XT-4-PR click into place in the lid of the
MIQ module. Subsequently, tighten the two screws (pos. 8 in
Fig. 3-4).
8 Close the cover of the DIQ/S 182-XT-4-PR and fix it in place
with the two countersunk bolts (pos. 7 in Fig. 3-6).
7
MIQ module
DIQ/S 182 XT-4-PR
5
1
2
For stack mounting remove label
and install contact carrier
4
3
MIQ module
DIQ/S 182 XT-4-PR