User manual

Installation System 182-XT-4

3 - 10

ba76027e02 12/2014

NOTE

For optimum stability only one MIQ module may be attached to the

DIQ/S 182 XT-4-PR.

Materials required  2 x ISO blind nuts (M4)

 2 x cheese-head screws (M4x16) with plastic washer

 1 x contact base with two plastic tapping screws (scope of delivery

of the MIQ module).

Tools  Phillips screwdriver.

Both installation variants of the attachment of an MIQ module on the

DIQ/S 182 XT-4 is described in the following. The assembly of further

MIQ modules is carried out analogously. To dismantle a stack, proceed

in the reverse order to mounting.

3.4.2 Variant 1: Stack expansion forwards

Preparing the stack

mounting

Fig. 3-2 Preparing components for stack mounting (variant 1)

In all MIQ modules in the System 182 XT-4 the terminator

switch on the terminal strip must be set to "Off".

For stack mounting remove label

and install contact carrier

MIQ module

DIQ/S 182 XT-4_PR