Instruction Manual

9
ENGLISH
E 132
1
Prt – Transmitting stored data (to Printer or PC)
Note: To print data, or to transmit to a PC, the optional Series 900 Data Hub(Inf-
raredInterfaceModule)isrequired.
The Series 900 Data Hubandtheconnectedprinter/PCmustbeready.Press
the[MODE]keytostartthetransmitting,theinstrumentdisplays“PrtG”(Printing)
forapprox.1secondfollowedbythenumberoftherstdatasetanditstransmis-
sion.Alldatasetswillbetransmittedoneaftertheother.Afternishingtheinstru-
ment returns to test mode.
Theprintjobcanbecancelledbypressingthe[On/Off]key.Theinstrumentturns
off.
IftheinstrumentisnotabletocommunicatewiththeIRiM,atimeoutoccursafter
approx.2minutes.TheerrorE132isdisplayedforapprox.4seconds.Subse-
quently, the instrument returns to test mode (see also IRiM manual).
2
Setting date and time (24-hour-format)
Afterconrmingtheselectionwiththe[MODE]keythevaluetobeeditedwillbe
shownfor2sec.
Thesettingstartswiththeyear(YYYY)followedbytheactualvaluetobeedited.
Thesameappliesformonth(mm),day(dd),hour(hh)andminutes(mm).Setthe
minutesrstinstepsof10,pressthe[!]keytocontinuesettingtheminutesin
stepsof1.
Increasethevaluebypressingthe[MODE]key.
Decreasethevaluebypressing[ZERO/TEST]key.
Proceedtothenextvaluetobeeditedbypressing[!]key.
Aftersettingtheminutesandpressingthe[!]keythedisplaywillshow“ISSET”
and the instrument returns to the measurement mode.
On
Off
PrtG
Prt
1
Store Date
Time Cal
Mode
!
SET
DATE
YYYY
(2 sec.)
Mode
Zero
Test
Time Cal
Store Date
2
3