User Manual

YSI 5200A
88
YSI 5200A
89
5200A slave alarms will be sent. erefore, It is critical that all alarm
emails are addressed locally by the user.
Below is an example of a 5200A DO Alarm Low email sent from AquaManager. All
of the information is in the body of the email and not the subject line.
YSI5200A Alarm
slave 2 (node name in Aquamanager tree)
53-2345567
DO Low Alarm: 68
Notes on AquaManager Alarm Emails:
AquaManager emails are retransmitted based on the Email Retry Delay -
Conguration see page 96.
Multiple system alarms are included in one AquaManager email. -
AquaManager DO alarm emails provide the %Sat value and do not pro- -
vide the mg/L value.
For the AquaManager alarm email to function properly, it may be neces- -
sary to send a test email to each email address congured in the Email
Alarm List in the Node Properties window. Test emails can be sent in the
AquaManager Properties window under the Autopoller tab.
Ethernet
Menus → System → Communications → Ethernet
e serial to ethernet device (TCP/IP connections) must be congured for 5200A
email alarming and/or remote access from AquaManager. Device speed and format
are self congured at power up. If the serial to ethernet device is not installed or is
not installed properly, the Ethernet Menu will display (Not Available).
Notes:
5200A email alarming from a serial to ethernet device requires access to -
an SMTP server accessible by the local network.
Do not recongure internal serial to ethernet device settings. -
Conguring the 5200A
Install serial to ethernet device - 1. page 59.
e Ethernet icon
2. displays at the Run Screen when the serial to ethernet
device is properly installed.
Enter Ethernet menu:3.
Menus → System → Communications → Ethernet
Use4.
▲
and
▼
to scroll and highlight submenus.
Press5.

to select submenu.
Congure submenus as needed.6.
Press 7. to save conguration and return to Run Screen.
Notes:
e CC/Email address must be congured when using 5200A email alarm-
-
ing. Specic alarm system information will not be sent if the CC/Email
address menu is not congured with a valid email address.
- If Autopoller is being used for AquaManager email alarming on a TCP/
IP connection, it is strongly recommended that the 5200A email alarm-
ing using the serial to ethernet device be disabled. When the ethernet
device sends alarm emails, all Autopoller SMS communication is sus-
pended. is could potentially delay any AquaManager alarm emails
from being sent.
- To disable the serial to ethernet device from sending alarms, clear all four
email addresses from the Communication → Ethernet menus. Clear the
email addresses by using the “Spc” (space) key on the numeric keypad.
Save change at numeric keypad and press
to save conguration
and return to Run Screen.
DHCP
Enable DHCP if you are using the serial to ethernet device only for 5200A email
alarming and not for AquaManager remote TCP/IP access.
Notes:
When DHCP is enabled, the 5200A IP address is not updated at the IP -
Conguring the 5200A