User Manual
YSI 5200A
38
YSI 5200A
39
Figure 3.13
Accessing the I/O Board
e I/O board is accessible when the 5200A front panel is removed. e letters on
the metal plate attached to the I/O board identify pluggable terminal strips on the
I/O board. Letters on the metal plate correspond to the wiring diagram located
on the inside of the front panel - gure 3.14. A ribbon cable connects the display
board (mounted in the front panel) to the I/O board. When the 5200A front panel
is removed, a lanyard protects against stress on the ribbon cable. See Open Front
Panel to Access I/O Board - page 39.
Installation and Wiring
Figure 3.14
Open Front Panel to Access I/O Board
WARNING: Disconnect external power to the unit before doing any wir-
ing.
AVERTISSEMENT : déconnectez l’alimentation externe de l’unité avant
d’ouvrir le panneau avant.
Loosen the 4 mounting screws connecting the front panel to the back 1.
enclosure. Captive screws remain in front panel aer loosening.
Carefully li the 5200A front panel from the back enclosure. Front panel 2.
should be placed to the le of enclosure. Allow the lanyard to hold the
weight of the front panel. e rubber gasket seated in the front panel
should remain in the front panel lid.
Installation and Wiring