User Manual

YSI 5200A
20
YSI 5200A
21
THIS IS IMPORTANT
Take time to be safe when working on electrical circuits and equipment. It could
save your life. Avoid unsafe acts and conditions. Do not operate or install the 5200A
before reading this chapter. Installing the 5200A involves wiring high voltage equip-
ment. Follow all provided safety information. Installation must be performed by
someone who understands the dangers of, and is qualied to, wire electrical devices.
If information or instructions are not clear, DO NOT PROCEED until clarication
can be obtained.
ALWAYS:
Follow basic safety rules when working with or near high voltage circuits. e
5200A is a high voltage instrument using 110v. Peripheral devices may also be
high voltage devices.
Consider the result of each act. Keep away from live circuits. Do not change
parts or make adjustments inside the equipment with high voltages on.
Do not service alone.
Do not tamper with interlocks. Safety devices such as interlocks, overload re-
lays, and fuses should never be altered or disconnected except for replacement.
Safety protection devices should never be changed or modied without a clear
understanding of what eect the modication will have on the system.
Do not ground yourself.
Do not energize equipment if there is any evidence of water leakage.
Warnings and Cautions
Safety information is presented in this manual in one of two ways:
- WARNING - RISK OF ELECTRIC SHOCK is symbol identies
installation and operation procedures that can result in personal injury
or death if safety information is not followed.
- AVERTISSEMENT – RISQUE DE CHOC ÉLECTRIQUE. Ce symbole
identie les procédures d’installation et d’opération pouvant entraîner
des blessures ou la mort si les consignes de sécurité ne sont pas suivies.
Safety
- CAUTION - RISK OF DANGER is symbol identies installation
and operation procedures that can result in personal injury or damage
to equipment if safety information is not followed.
ese symbols (
) ( ) appear in the le margin of the page to highlight
safety information as it applies to a particular installation or operation step.
A complete list of all safety cautions is provided below. All warnings are provided
in English and French.
Install and use the 5200A only in accordance with information documented in this
manual.
Warnings
WARNINGS are used when personal injury or death can result if safety informa-
tion is not followed.
WARNING: All wiring that involves connections to mains power must be
performed by a qualied licensed electrician, and must conform to all locally
applicable electrical codes.
AVERTISSEMENT : tous les câblages comportant une connexion à l’alimentation
secteur doivent être réalisés par un électricien qualié et doivent être conformes
aux codes électriques applicables.
WARNING: Do not make connections while power is applied. Turn o power
and assure power “Lockout” before installing or servicing to avoid contact with
electrically powered circuits. is includes working on devices connected to the
relay outputs and auxiliary input systems. Disconnect external power to the
5200A before connecting or disconnecting components and/or peripheral
devices.
AVERTISSEMENT : n’eectuez aucune connexion alors que le circuit est sous
tension. Coupez l’alimentation et assurez l’interdiction du courant avant toute
installation ou tâche d’entretien an d’éviter d’entrer en contact avec des circuits
sous tension. Cela comprend tout travail sur des appareils connectés à des sorties
de relais et des systèmes d’entrée auxiliaires. Déconnectez l’alimentation externe
du modèle 5200A avant de connecter ou de déconnecter des composants et/
ou des appareils périphériques.
WARNING: A switch or circuit breaker shall be included in the building where
the 5200A is installed. e disconnecting device should be in close proximity to
Safety