Owner's manual

YSI 5200A
99
YSI 5200A
98
- Conguring a 5200A as a Master overrides any slave conguration that
had been previously saved.
- Slave alarms (slave alarm at master and 5200A alarm emails) will not oc-
cur if slave node serial number is not recognized at master node at steps
10. A or 10. B above.
Termination Relay
Menus → System → Communications → Network →Termination Relay
e termination relay must be enabled on the rst and last 5200A on a network. All
other devices should have the termination relay disabled.
Send Test Email Msg
Menus → System → Communications → Send Test Email Msg
Send a test email to verify proper conguration of ethernet menus. Test emails are
only transmitted from congured master 5200As.
Note:
- Test emails are sent to all congured email address.
- Exit to Run Screen is required before the test email is sent.
Example of a 5200A test email sent from an ethernet device:
Subject Line: 02/04/10 03:50:05 PM YSI5200A Email Alarm Test Message
From: [e-mail]
Sent: Wed, Feb 04, 2010 3:49 pm
To: [e-mail]
CC: [e-mail]
Conguring the 5200A
Email Retry Delay
Menus → System → Communications → Email Retry Delay
Congure the Email Retry Delay for the time interval that emails should be retrans-
mitted aer the initial alarm email is sent. e initial alarm email is sent immediately
aer the general alarm hold o time or aer the aux hold o time. Emails will be
retransmitted until one of the bottom front panel sokeys is pressed, regardless if
the alarm condition still exists.
Note:
- On a network, emails are retransmitted according to the slave retry delay
conguration of the slave in alarm and not the master’s email retry delay
conguration. Please note, a slave Email Retry Delay menu will display
(Not available) because of its slave conguration; however, this feature
is available and has a default value of 15 minutes that can be congured
by the user.
- e Retry Delay should be congured at intervals ≥ 15 minutes.
- AquaManager alarm emails are retransmitted based on the 5200A slave(s)
and master email retry delay conguration.
Baud Rate RS232
Menus → System → Communications → Baud Rate
Congure the Baud rate (for RS232 connections only) in the 5200A to match the
baud rate congured in AquaManager. Use the default rate of 115200 for fastest
communication speed.
1. Enter Network menu
Menus → System → Communications → Network →Baud Rate
2.
Press
▲
or
▼
to scroll and highlight a selection.
3.
Press

to conrm selection.
4. Press
to save conguration and return to Run Screen.
Conguring the 5200A