Owner's manual

YSI 5200A
251
YSI 5200A
250
Index
Probes
calibration 74
connect probe assembly 61
locate and install probe assembly
5561 probe assembly 35
5562 probe assembly 36
name probe (sensor) systems 119
probe (sensor) setup. See Sensor setup menu
R
Rail mount 5200A 28
Recycling 241
Relays
relay test 127
wiring 46
Reset to factory
reset all 125
reset clean probe timer 123
reset sensors 126
reset system(s) 125
reset timers 127
rubber grommets. See Bulkhead ttings
Run Screen 68
S
Safety
cautions 23
warnings 21
Salinity 131, 153
Sensor log. See Data Logging menu
Sensors
and Feed Smart timer 162
“check probe” 75
guard 35, 36
name 119
“over” and “under” values 132
port plugs 76
probe assemblies. See Probes
Sensor setup menu
aux (non temperature)
Index
digital 142
relay 142
relay 144
conductivity 145
temperature compensation 146
timed and normal control 145
DO 147
ORP 149
pH 150
set points, controls, alarms 135
temperature 151
range high control 151
Serial number 123
Service hold 128
Service hold menu 169
congure service hold enable and hold off 128
Service menu 123. See also Reset to factory
SMS messaging 95
SMS messaging formats 238
Softkeys 67
Specications
inputs
aux 14
sensors 14
systems (non input) 16–17
communication 17
ethernet module 17
RS232 17
rmware 17
hardware
relays 16
Stub (network wiring) 53
Submenu screen types 73
Subnet mask (ethernet menu) 92
Surface mount 5200A 28
Surge and lightning protection 62
Systemwide event 108