Owner's manual

YSI 5200A
203
YSI 5200A
202
Menu Map Key
e following conventions are used in menu maps:
- Factory defaults are contained in ( ). If blank, no default value is loaded for
this menu. In certain menus, the user conguration will appear in () once the
menu is congured.
- System range (if applicable) are in italics; “*” displayed aer the range indi-
cates that the range is based on another system conguration i.e. set point
submenus.
- (Not Available) indicates hardware is not installed or menu is not applicable
to system conguration.
e following graphics are used in menu maps:
- 7 - Input is required at numeric or alpha/numeric keypad.
-
- display of sokey indicates selection of sokey is re-
quired.
- q - Make a selection from a pull down menu.
- - Use three front panel key to proceed; (only used at adjust contrast
menu).
Menu Maps
Menu Maps
e menu map below depicts how the menu map conventions and graphics are
used for conguring the DO alarm low value and enabling the DO system alarms.
(complete DO menu is not shown in example)
MENU MAP EXAMPLE