User manual

2.7.Setting up YOYORouter EE1 in Ethernet WAN Mode

with Failover

First configure YOYORouter EE1 in Wireless WAN Mode and test the connection.

Next, configure YOYORouter EE1 in Cable and test the connection.

To enable WAN Mode with Failover, ensure that the USB Modem and Ethernet WAN are both

connected and follow these steps:

1. Log in.

2. Select Advanced then Net work Setup.

3. Against Activate WWAN for Auto-Failover

x Check Enable.

x Enter an IP address in Remote Host f or keep alive that YOYORouter can ping to

check the connectivity.

4. Make sure that Connection Control is set to Auto Reconnect (always on).

5. Click Save.

6. Select TOOLBOX, Reboot and OK to reboot YOYORouter.

7. Check that YOYORouter is normally connected to the cabl ed WAN connection

x System Status sho ws cabled connection details.

x Wireless Modem indicates Disconnected.