User guide

Setting up YOYORouter EE1 in Ethernet WAN Mode with Failover

First configure YOYORouter EE1 in Wireless WAN Mode and test the connection.

ext, configure YOYORouter EE1 in Cable and test the connection.

o enable WAN Mode with Failover, ensure that the USB Modem and Ethernet WAN are both connected

and follow these steps:

1. Log in.

. Select Advanced then Network Setup.

3. Against Activate WWAN for Auto-Failover

• Check Enable.

• Enter an IP address in Remote Host for keep alive that YOYORouter can ping to check the connectivity.

4. Make sure that Connection Control is set to Auto Reconnect (always on).

5. Click Save.

6. Select TOOLBOX, Reboot and OK to reboot YOYORouter.

7. Check that YOYORouter is normally connected to the cabled WAN connection

• System Status shows cabled connection details.

• Wireless Modem indicates Disconnected.

8. Unplug the cabled WAN plug and check that Failover occurs:

• 3G Failover indicated in System Status.

• Wireless Modem indicates Connected.

9. Re-connect the cabled WAN and check that service reverts to the WAN connection.