User guide

Setting up YOYORouter EE1 in Wireless WAN Mode
N
ote: A full list of supported USB modems is available from the Supported Cards List link in the status
page, or from www.yoyomotion.com.
1. Make sure your SIM card is installed in the USB modem. Consult the USB Modem’s documentation for
further information.
2. Plug in your USB Modem and turn on YOYORouter EE1. Allow at least 60 seconds for the USB modem
to be detected and configured.
In most cases YOYORouter EE1 self-configures and operates in Wireless WAN Mode using default
settings. You may need to customize the settings, for example in the following cases:
• Your SIM requires a PIN Code.
• Your mobile broadband subscription requires different settings to those that YOYORouter selected
by default.
• You have special mobile broadband settings, for example a private APN (Access Point Name).
• You wish to change Wi-Fi settings.
To customize settings:
3. Connect to YOYORouter via Wi-Fi or Ethernet, access the status page at http://192.168.1.1 and log in.
4. Select Wizard and step through the Setup wizard until you reach step Select WAN Type.
• Select WAN Interface option Wireless WAN.
• Select WAN Type 3G.
5. 3G Mobile Network Settings
• Connection settings are normally selected automatically from your SIM.
• Select Dial-Up Profile option Manual at the 3G step if you need to select alternative or enter special
settings. Select your country and the network operator, or Others to enter your own settings.
• If your SIM requires a PIN code, enter it now.
6. At the end of the Wizard, check The Ethernet Port will be set as LAN Port and click Apply Settings.
YOYORouter restarts.
7. If you are connecting using Wi-Fi, you may need to re-make the connection in line with your new
settings. If you are using an Ethernet cable, the connection will be active as soon as the reboot is
complete.
Note: In this mode you can also connect a device using the Ethernet LAN port.
If you do not require the Wi-Fi connection, it may be disabled for longer battery life.