Mobile Travel Router B1 Quick Start Guide www.yoyomotion.
Operating Modes YOYORouter B1 has three operating modes: Router Mode Make a Mobile Broadband Internet connection using HSPA/HSDPA/UMTS/ EDGE/GPRS and share over Wi-Fi. • Works with any Wi-Fi enabled device • No need to load software or drivers • Links up to 254 devices in a Local Area Network with Internet access.
. Insert the battery • WARNING: Always be sure to disconnect the power before inserting or removing the battery. • Hold the battery so that the three gold contacts align with the three gold pins in the compartment. • Insert the battery so that the contacts meet. • Press the other end of the battery in to the compartment so that it clips in to place. 4. Replace the battery compartment cover. • Place the cover over the battery compartment, leaving a gap of about 5mm.
Accessing the status and configuration pages. 1. While connected, open your web browser and enter http://192.168.1.1 The YOYORouter status page is displayed. 2. To view and change settings, enter the default password, admin, and click Login. Setting up YOYORouter B1 in Router Mode 1. With SIM and battery inserted, turn on YOYORouter in router mode by sliding the 3-way switch to the ROUTER position. 2. Allow at least 60 seconds for the mobile network to be detected and configured.
. Configure Mobile Network Settings • Select Dial-Up Profile option Manual at the 3G step if you need to select alternative or enter special settings. Select your country and the network operator, or Others to enter your own settings. • If your SIM requires a PIN code, enter it now. 6. Configure the Wireless LAN (Wi-Fi) settings • Change the Network name (SSID) to a name of your own choice, if required • We recommend WPA-PSK / WPA2-PSK security; the settings shown provide widest compatibility.
Setting up YOYORouter in Share Mode 1. Turn on YOYORouter in router mode by sliding the 3-way switch to the ROUTER position. 2. Connect to YOYORouter, access the status page at http://192.168.1.1 and log in. 3. Select the configuration wizard. 4. When you get to Select WAN Type in the Wizard, select WAN Type Wi-Fi Hotspot and click Next> 5. YOYORouter scans for available Wi-Fi networks and presents a list; select the required network. 6.
Setting up YOYORouter in Modem mode 1. Connect the included USB cable to the mini USB port of YOYORouter. 2. Connect at least the USB plug with two cables to your PC. Connecting both enables the battery to charge faster. If connecting to a USB hub, it must be the type that has its own power supply. 3. Turn on YOYORouter in MODEM mode by sliding the 3-way switch to the MODEM position POWER ROUTER OFF MODEM 4. The installation wizard appears automatically; follow the steps. Keep YOYORouter switched on.
Connecting to the YOYORouter using WPS Wi-Fi Protected Setup, WPS, is a simple way to connect to the YOYORouter without needing to give the new user the Pre-Shared Key (password). Pushbutton mode provides the simplest possible configuration: 1. Locate the WPS pushbutton on the device that you wish to connect to the router. This may be a physical button or a clickable pushbutton in the software provided with the device. 2. Press and hold the YOYORouter WPS button for 5 seconds.
