User manual

8
2.2.Preparing YOYORouter BE5
Follow these steps to connect up your YOYORouter and access the configuration wizard to
configure it to your needs.
1. Attach the 3G antenna
 Locate the antenna’s plug against the antenna socket on the rear panel.
 Turn the grooved ring clockwise to secure the plug in the socket.
 Once secured, position the antenna to point vertically upwards. This will ensure optimal
reception
2. Insert the SIM card
 WARNING: Always be sure to disconnect the power before inserting or removing the
SIM card. Do not touch the gold contacts of the SIM Card.
 Hold the SIM card in line with the slot (gold contacts on the underside) and insert it
gently until it clicks in to place.
 When in place, the SIM card projects from the back panel by approximately 2mm.
 To remove the SIM, press gently inwards until you hear a click; the SIM card will then be
ejected.
Note: A SIM card is not required if the BE5 is to be used in Ethernet WAN Mode only with no
phone or SMS.
3. Connect the WAN Cable
 Plug in the Ethernet (RJ45) cable from the internet connection, for example a cable or
ADSL modem.
 Ensure this cable is connected to the WAN port as shown.
 When used in Mobile Broadband mode, it is not necessary to connect the WAN cable.