User manual

74
 Ensure that the LEDs are indicating normally. If not, make sure that the AC power
adaptor is connected.
 If you are using other wireless device, home security systems or ceiling fans, lights in
your home, your wireless connection may degrade dramatically. Keep your product
away from electrical devices that generate RF noise such as microwaves, monitors,
electric motors…
My Wi-Fi connection drops or is unreliable
 Position YOYORouter and clients closer together
 Avoid solid walls and other obstructions which reduce the range of the Wi-Fi signal
 Try different antenna orientations for the YOYORouter – stand the device vertically for
example.
 Try to keep YOYORouter at least 15cm away from the wall or other objects.
 Try changing the channel on the YOYORouter to avoid interference from other Wi-Fi
networks. (By default YOYORouter tries to find a channel with low interference)
 Keep YOYORouter and clients away from electrical devices that generate RF noise,
like microwave ovens, audio and TV senders, electric motors, etc.
I have lost the Wi-Fi password
 The default network password is printed on the device label and on the label affixed to
the carton in which the device was packaged.
I need to connect a device that does not support WPA or WPA2 /
I want to run YOYORouter in Open or WEP security mode
YOYORouter’s default configuration is to accept connection using WPA(TKIP) or WPA2(AES).
To change YOYORouter to open or WEP mode:
1. Connect to YOYORouter using a device that does support WPA or WPA2 and enter
the WPA password printed on the device’s label, or connect using Ethernet.
2. Open the browser at 192.168.1.1,
3. Log in and use the configuration wizard or change settings Advanced > Basic >
Wireless > Authentication & Encryption to suit the device that you need to connect.
4. Allow YOYORouter to reboot
5. Reconnect using the new security settings.
I changed the default Wi-Fi password and cannot remember what password I set
 You must reset YOYORouter to factory state.
 Connect using the default network password printed on the device label and on the
label affixed to the carton in which the device was packaged
 Open the browser at 192.168.1.1 and log in (password: admin)
 Make any necessary configurations again using the Wizard or the Advanced
configuration pages.
I cannot locate the default password for my YOYORouter
The default network password is printed on the device label and on the label affixed to the
carton in which the device was packaged. If these labels are missing or damaged:
 Contact YOYOMotion. If possible please supply the MAC address, serial number or
IMEI of the device in question.
I am connected to the YOYORouter Wi-Fi network but cannot access the configuration
pages
By default the configuration pages are reached by opening the browser on a connected device
and selecting 192.168.1.1
 If you previously changed the IP address range, for example to 192.168.123.254, you
must use this address to access the configuration pages