User manual

Click on “Save” to store your setting or “Undo” to give up.

3.2.4.5.Routing

Routing Tables

Allow you to determine which physical interface address to use for outgoing IP data grams. If

you have more than one routers and subnets, you will need to enable routing table to allow

packets to find proper routing path and allow different subnets to communicate with each

other.

Routing Table settings are settings used to setup the functions of static and dynamic routing.

Dynamic Routing

Routing Information Protocol (RIP) will exchange information about destinations for

computing routes throughout the network. Please select RIPv2 only if you have different

subnet in your network. Otherwise, please select RIPv1 if you need this protocol.

Static Routing

For static routing, you can specify up to 8 routing rules. You can enter the destination IP address,

subnet mask, gateway, hop for each routing rule, and then enable or disable the rule by

checking

or un-checking the Enable checkbox.

Click on “Save” to store your setting or “Undo” to give up.