User guide

Preparing YOYORouter BE5

ollow these steps to connect up your YOYORouter and access the configuration wizard to configure it to

your needs.

. Attach the 3G antenna

• Locate the antenna’s plug against the antenna socket on the rear panel.

• Turn the grooved ring clockwise to secure the plug in the socket.

• Once secured, position the antenna to point vertically upwards. This will ensure optimal reception

2. Insert the SIM card

• WARNING: Always be sure to disconnect the power before inserting or removing the SIM card.

Do not touch the gold contacts of the SIM Card.

• Hold the SIM card in line with the slot (gold contacts on the underside) and insert it gently until it clicks

in to place.

• When in place, the SIM card projects from the back panel by approximately 2mm.

• To remove the SIM, press gently inwards until you hear a click; the SIM card will then be ejected.

Note: A SIM card is not required if the BE5 is to be used in Ethernet WAN Mode only with no phone or

SMS.

3. Connect the WAN Cable

• Plug in the Ethernet (RJ45) cable from the internet connection, for example a cable or ADSL modem.

• Ensure this cable is connected to the WAN port as shown.

• When used in Mobile Broadband mode, it is not necessary to connect the WAN cable.

4. Connect the Power Cable

• Connect the cable from the power adaptor to the power inlet socket on the back panel, as shown

• Plug the power adaptor in to a wall outlet or socket strip.

• Turn on YOYORouter using the on-off switch next to the power connector