User's Manual

Page 15
No 2 (Blue) : Negative Starter-Kill Output
Please use the pre-wired starter kill relay.
Page 14
No 1 (Green) : (+12V)Ignition Input
This wire will test (using your digital multi-meter) 0V with the key off, and 12V with
the key in the ‘ON or RUN’ ‘position
C0N3
87
Relay
85
86 30
87a
Cut
Starter
Key Cylinder
Starter Wire
OFF
ACC
ON
START
.... Anti Jacking Mode ...
87
Relay
85
86 30
87a
Cut
Engine
Key Cylinder
Ignition Wire
OFF
ACC
ON
START
.... Starterkill Mode ...
No 3 (Red/Black) : Negative Trigger Door Open Sense
No 4 (Red) : Positive Trigger Door Open Sense
+12V
CON3-3(-) Door Trigger
Dome Light
Door
Trigger SW
Door
Trigger SW
+12V
CON3-4(+) Door Trigger
Dome Light
Please make sure you have found a correct door sensing wire that monitors all doors.
No 5 (Violet / Black ) : (-)Trunk Trigger Input.
connect this to wire to the trunk lamp wire as shown below
No6 (Light Blue / White) : (+) Brake Trigger Input
Connect this wire to the foot Brake Wire as shown below.
+12V
CON3-6(+)Brake Trigger
Stop Lamp
Foot Brake S/W
CON 3-5
(-)Trunk Trigger Input
Trunk Lamp
+12V
< External Actuator>
Method 3 : External Actuator