User's Manual

Page 16 Page 17
This mode allows a valet to operate your car with your authorization without him or her
triggering all the security features or remote-starting your vehicle. Also, Valet Mode is
very useful when washing your vehicle or having it serviced.
In order to enter Valet mode, press Buttons ( I+III ) simultaneously for a second.
The remote-pager CompuGLO LCD will display a ZZZ icon indicating that you are in Valet
Mode. In order to manually enter Valet Mode, insert your car key into the ignition and turn
the ignition on and off five times within 10 seconds.
See the illustration below for a typical ignition harness of a vehicle.
In Timer Start Mode, your car automatically starts every 1.5 or 3.0 hours depending on
preset options during the time of installation for a 24-hour period. This mode is deleted
automatically after 24 hours or once you start your car with either your manual key or
remote-pager. In order to enter Timer Start Mode, press Buttons ( II+IV ) simultaneously
for a second.
You can exit Valet Mode only by pressing Buttons
( I+III ) simultaneously for a second.
Timer Start Mode
A red-bordered indicator box labeled Timer will darken on the top of your CompuGLO
LCD demonstrating that you are in Timer Start Mode.
Press Buttons ( II+IV ) simultaneously for a second to exit Timer Start Mode.
Timer Start Mode is automatically cancelled when you start the vehicle with the key
or by remote.
Also, note that Timer Start Mode becomes Cold Start Mode once an optional
temperature sensor is installed. See page 18 for more details.
Important!
Timer Start Mode should be used only in open areas.
Never start and run the vehicle in an enclosed space such
as a garage or carport.
OPTIONAL PROGRAMMABLE FEATURES
These additional programmable features can be programmed to the CompuStar
system by your authorized CompuStar dealer.
Passive Arming
You can turn this function on or off by pressing Buttons ( II+III ) for a second.
When set to passive arming, your security system will arm automatically 30 seconds
after all the car doors are closed. There are two types of passive arming that can be
programmed by your CompuStar dealership : (1) passive arming with passive lock and
(2) passive arming without passive lock.
Passive locking means the door will lock when the system passively arms. In the default
factory setting, the system is armed and locked actively which means the system will only
arm/lock when the remote-pager is utilized.
Ignition Lock
This programmable option enables your vehicle to automatically lock the doors upon
pressing the brake pedal after the vehicle has been started with a key. In addition, the
vehicle will automatically unlock the doors upon pulling the key out from the ignition.
This option must be chosen at the time of installation.
Safety Shut Down Features
If this optional Turbo Mode has been programmed at the time of installation,
you can turn this feature on and off by pressing Buttons ( III + IV ) for a second.
Under this mode, engine continues running for 2 minutes after key has been taken out
from the ignition if emergency brake was on when the key is taken out. To utilize this
mode, the emergency brake sensing wire has to be connected to the emergency brake
wire of the vehicle. Consult the authorized dealer for this mode.
Turbo Mode