User's Manual
Page 14
Your vehicle is now ready for auto-starting. However, the reservation mode will be can
celled if the door is opened or the CompuStar system is put in Valet mode after the re
servation has been set. Once cancelled, you will have to start the vehicle with the manual
key and repeat the above 5 steps if you want to restore reservation mode.
In order to auto-start your manual transmission car, you must first set the CompuStar
system to Reservation Mode before leaving your vehicle. The purpose of Reservation
Mode is to leave the transmission gear in the neutral position when you leave your vehicle.
Reservation mode is intended for use in MANUAL TRANSMISSIONS ONLY and NOT
FOR AUTOMATIC TRANSMISSIONS. Reservation Mode must be engaged each and
every time you leave your manual transmission car in order to auto-start the vehicle.
Note :
The system is not recommended for vehicles with removable tops.
ᵉ
Important Requirements to activate Reservation Mode
⍥
The transmission must be in the NEUTRAL position.
⍥
The vehicle windows must be rolled up.
⍥
Do not set the reservation mode with people in the vehicle.
⍥
Do not auto-start the car with people in the vehicle.
ᵉ
Activating Reservation Mode (MANUAL TRANSMISSION ONLY)
Step1 :
After arriving at your destination, and BEFORE TURNING YOUR
ENGINE OFF, place the transmission in the Neutral position.
Step2 :
Remove your foot from the foot brake.
Step3 :
Activate the parking brake.
Step4 :
Remove the key from the ignition. The engine will remain running.
Step5 :
Exit the vehicle and close the door within two minutes after activating
the parking break. The engine will shut off and reservation mode for
the remote starter is now complete.
Reservation Mode
(manual transmission only)
Important!
If you try to auto-start the vehicle when reservation mode has
not been set or turned on, the auto-start feature will not work.
When you press the auto-start button, the car parking lights will flash three times
and the door icon in the CompuGLO LCD will be flashing to inform you that reserva-
tion mode has not been set.
Page 15
ᵉ
Canceling Reservation Mode
If you do not want to set reservation mode, shut off the engine before you exit the
vehicle. The engine will shut off for the following reasons :
⍥
You did not activate the parking brake or pressed the foot brake when you
turned the manual key to the off position.
⍥
You released the parking brake while the engine was running.
⍥
You entered Valet Mode after the Reservation Mode has been completed.
Trunk Release
Press Button
III
for 2 seconds in order to unlock and release your trunk door.
Note that the trunk release function will not only release the trunk but will unlock all the
doors as well.
Query Function
Query Function allows the owner to visually monitor the status of your car by looking at
the remote-pager CompuGLO LCD icons. Press Button
IV
for a second to activate
the Query Function.
Vibration Mode
If the vibration mode is turned on, the Remote-Pager will vibrate instead of beep only
when one of the entry points or shock sensor inputs is triggered. You can turn vibration
mode on or off by pressing Buttons (
II
+
III
) for 2 seconds.
Car Siren
The car siren chirps once for lock and twice for unlock. You can delete this audible
chirping by pressing Buttons (
I
+
II
) for a second and the car siren icon will disappear
on the CompuGLO LCD.
Valet Mode is intended to deactivate most of the features of your CompuStar 2WSSR
system especially the security alerts/monitoring and remote starting. The only feature
operating in valet mode is the keyless entry function and optional auxiliary functions.
Valet Mode