User's Manual
Page 11
Remote-Pager Factory Reset Procedure
USING YOUR SYSTEM
You can reset the remote-pager by removing the AA battery and reinsert it back into the
remote-pager. Please perform this procedure in close proximity to the vehicle.
Your CompuStar 2WSSR system has many different modes and functions that can be
activated by using your remote-pager unit.
Alarm Mode
You can arm or disarm alarm mode by pressing Button
I
for a second or 2 seconds.
A bolted padlock icon will appear on your CompuGLO LCD indicating that your car is
armed and a lock icon will appear showing that your car doors are locked. Also, your
car will chirp when you arm or disarm your car.
Press Buttons (
I+II
) for a second to make your car siren mute when arming or
disarming your vehicle. A car siren icon will disappear on the bottom left-hand corner
of your CompuGLO LCD indicating that you are in car siren mute mode.
Keep in mind that your car siren will still activate for all other modes (i.e. panic, alarm,
shock sensor) regardless of whether or not your car siren is in mute mode.
The car siren will be mute only when arming or disarming your vehicle.
When alarm mode is armed, the following will trigger the remote-pager security alerts :
Unauthorized car door opening will activate the car siren for 30 to 60 seconds and
the parking lights will flash for 60 seconds. The remote-pager will be notified audibly,
vibrate and the door icon will appear in the CompuGLO LCD. Press Button
I
for a
second to turn off the car siren and flashing lights. Repeat this step ( press
Button
I
for a second ) again to disarm alarm mode.
Unauthorized trunk door opening will activate the car siren for 30 to 60 seconds and
the parking lights will flash for 60 seconds. The remote-pager will beep, vibrate and
the trunk door icon will appear in the CompuGLO LCD. Press Button
I
for a
second to turn off the car siren and flashing lights. Repeat this step ( press Button
I
for a second ) again to disarm alarm mode.
Page 10
Remote-Pager Learning
1.
Remote Learning :
Take the AA battery out from the remote.
Turn the key on/off 5 times. If you hear a
relay clicking sound, you are in the learning
mode. Then, put the battery in.
You will hear a clicking sound once, that
means the controller module learned the
remote. Soon, you will hear two relay clicking
sounds, that means the controller is exiting
the learning mode. A few seconds later,
you will hear a confirmation beep from the
remote. If you do not hear the confirmation
within 20 seconds after you put the battery
in, Remove the battery, and put it back in
without cycling the ignition on/off 5 times.
2.
Replacing a battery :
Whenever you replace a battery, do so within
the transmitting range between the remote
and the antenna. If you take the battery out,
the synchronization between the antenna and
remote is broken. When you put the battery in,
the remote will attempt to synchronize with the
antenna. Within a few seconds the remote
will confirm with two beeps indicating synchro
nization has been completed. If you do not
hear any confirmation beeps within 20
seconds, you will have to remove the battery
and put it back in.