User's Manual
My manual transmission car is not auto-starting remotely.
Most likely, you did not push Button
II
for the required 2 seconds. Pushing Button
II
for
only a second engages the optional auxiliary function instead of auto-start.
For manual transmission cars, the vehicle must be in reservation mode before you can
auto-start your car remotely. If your remote-pager door icon flashes and beeps three
times along with your car s parking light flashing three times when you try to auto-start
your manual-transmission car, reservation mode has not been set. Please see page 11
of this manual for instructions and important requirements to activate reservation mode.
Another reason maybe that you are in Valet Mode. If there is a ZZZ icon on your remote-
pager unit, you are in this mode and all the functions of the CompuStar 2WSSR are dis-
abled except for keyless entry. Press Button (
I
+
III
) simultaneously for a second to
deactivate Valet Mode.
If there is a problem in auto-starting your car, you will hear three chirps from your remote-
pager when you attempt to auto-start the vehicle. After waiting two seconds, the diagno-
sis for the auto-start error will be indicated depending on the number of times the car
chirps and parking lights flash. For example, 4 car chirps and parking light flashes indi-
cates that the car did not auto-start because the trunk was open. Please see page 13
of the user s manual for the error diagnosis table.
My car is armed in alarm mode and my remote-pager is not working or I do not have my
remote-pager. How do I avoid triggering the CompuStar starter kill function so I can drive
my car ?
Unlock the car door with your manual key, which will trigger the car s siren and parking
lights. You must manually override the CompuStar security and auto-start functions by
putting the car into Valet Mode. This mode will disable all the functions of the CompuStar
except for keyless entry.
In order to enter Valet Mode, cycle the ignition key from the off position to the on position
5 times within a 10 second period. You are now in Valet Mode and have disabled the
CompuStar 2WSSR security system except for keyless entry.
I keep banging on my RPS (remote paging system) sensor but it is not working.
RPS sensor is usually located on the outside edge of the driver s side front window
shield and detects high frequency vibration. Therefore, in order to properly activate RPS,
the user must produce a high-frequency sound by tapping with a car key where the RPS
sensor is located. Simply pounding on the front windshield with your hand will not pro-
duce the required high frequency vibration and therefore will not activate the RPS
system.
How do I deactivate my RPS audible and visual (telephone icon) paging alerts on my
remote-pager?
Press Button
I
,
II
,
III
or
IV
for a second to deactivate the RPS paging alerts.
My remote pager unit is not beeping audibly when I push the buttons.
Check to see if you are in remote-pager vibration mode by observing a vibration icon
that appears continuously in the upper left-hand corner of your CompuGLO LCD screen.
Press Buttons (
II
+
III
) for 2 seconds to deactivate vibration mode and the vibration icon
will disappear.
My car is not chirping when I arm or disarm alarm mode.
Check to see if you are in silent arm/ disarm mode by observing a car siren icon in the
bottom left-hand corner of your CompuGLO LCD Screen. Press Buttons (
I
+
II
) for a
second to deactivate the car siren when arming/disarming your vehicle and the car siren
icon will disappear. Keep in mind that your car siren will still activate for all other modes
(i.e. panic, alarm, shock sensor, etc) regardless of whether or not your car siren is in
mute mode.
Page 22 Page 23