User's Manual

ManualsBrandsYoungshin Electronics ManualsAutomotiveCar alarm

CM3000

INSTALLATION GUIDE

CM3000

YOUNG SHIN Electronics Co., Ltd.

www.MAGICAR.com

FCC ID : 044JMA510SS

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions :

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference

that may cause undesired operation.

CAUTION :

Changes or modifications not expressly approved by the party

responsible for compliance could void the user

s authority to

operate this device.

INSTALLATION GUIDE

Compustar A Controllers

Summary of content (8 pages)

PAGE 1
000 CM3 CM3000 Compustar A Controllers INSTALLATION GUIDE FCC ID : 044JMA510SS INSTALLATION GUIDE CM3000 YOUNG SHIN Electronics Co., Ltd. www.MAGICAR.com This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
PAGE 2
TABLE OF CONTENTS ᵄ Wiring Diagram ᵄ Installation of FM or SS Antennas and RPS ᵄ Option Programming for Four Button Remote ᵄ Option Programming for Six Button(ONE WAY) Remotes ᵄ Remote - Pager Programming Menu Options ᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍ Page 2 Page 4 ᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍ Page 5 ᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍ Page 6 ᴍᴍᴍᴍᴍᴍ Page 7 ᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍᴍ Page 7
PAGE 3
Important! Under normal circumstances, Reservation Mode is cancelled Your Warranty The product s warranty is automatically void if its date code or serial number is defaced, missing or altered. This warranty will not be valid unless you have completed the regis tration card and mailed it to Firstech, Inc., within 10 days after the purchase to the address listed on the registration card. Important Information Congratulations on the purchase of your high-tech vehicle security system and remote auto-starter.
PAGE 4
Remote-Pager Button Functions Icon Shock Turbo Timer Passive Explanation Indicates if the Shock Sensor is on or off. See page 12. Indicate if Turbo Mode is on or off. See page 17. The user can activate differing functions of CompuStar 2WSSR system by pressing one or two buttons simultaneously (ex.(I+IV) ) located on the antenna side of your Compu Star remote-pager. Channel Indicates if Passive Arming Mode is on or off. See page 17.
PAGE 5
Wiring Diagram (-) Output for Parking Lights : Some vehicles, such as Jeep, have negative Parking lights. (+) Siren Output (+) Parking Light 12V Constant Ground An Aux output is a 5sec pulse that can be changed to Latch. See Programming Options.
PAGE 6
Option Programming for Four Button Remotes Step1: For programming menu 1 : Press Buttons (I+II) for 2 seconds. For programming menu 2 : Press Buttons (I+IV) for 2 seconds. The car will chirp once indicating that you are in programming mode. Step2: Within a 2 seconds after pressing (I+II) or (I+IV), press Button IV the number of times to go to the option number you want to change. You will hear a chirp and see the parking lights flash each time when you press Button IV. Step3: Wait a few seconds.
PAGE 7
Important! In order for this feature to operate, the installer must use the 2nd Unlock Wire (Or/Bk wire of Connector 4). Isolate the driverᴗ s door actuator from the rest of the other doors. Call us for the technical support if you are not sure about this. Button Siren Installation required Starter Kill Panic Mode IV for 2 seconds 1.5 minutes Starter-Kill Activated immediately Anti-Jacking Mode IV for 2 seconds 1.5 minutes Ignition-Kill N/A Ignition Kill N/A Activated immediately if key is not on.
PAGE 8
Setting AUX No. 2-9 On Access to passive mode through a remote Non setting of passive mode Setting of passive mode off AUX 1 Button II Button I Button II AUX 2 Button III Button II Button III AUX 3 Button III AUX 4 Button IV AUX 5 Button II- AUX 6 Button III- AUX 7 Button IV- Output All outputs are connecting with Channel Expander through AUX1. AUX 1, AUX 2 Adjusting the Car Siren Volume: In order to decrease the chirping volume of the siren, cut the loop located on the siren.