User's Manual
Page 11
While the vehicle is in valet mode, only the keyless entry function will be available.
Valet Mode is very useful when loaning your vehicle or having it serviced.
In order to enter Valet mode, press buttons
(I+III)
simultaneously for a 1/2 second.
In order to manually enter Valet Mode, insert your key into the ignition and turn
the ignition on, then off,
(between ACC and ON)
five times within 10 seconds.
Valet Mode
You can exit Valet Mode only by pressing buttons
(I+III)
simultaneously for a 1/2 second.
Safety Shut Down Features
The Young Shin Electronics,Inc. 2W8000FMR, 2W8000FMR-2
nd
system has several
shut down safety features. The following actions will shut down the engine or prevent
the car from auto-starting : Opening the hood, pressing the brake, or if Valet Mode is
turned on.
away from the vehicle by more than 50 to 100 ft,
and (3) 15 seconds have passed
since the last Auto Disarm
. Your system will disarm automatically if your remote
comes within a 50 to 100 ft radius from the vehicle.
Setting Auto Arming Function.
The range varies significantly depending on the radio signal environment.
Each time you press button I for 2 seconds :
First time : Auto icon is turned on.
Second time : Auto icon flashes - for longer range.
Third time : Auto icon is turned off.
You can turn this function on or off by pressing button [I] for
2 seconds. When Auto arming is set, your security system will arm
automatically after (1) all the doors are closed, (2) your remote is
[ I ] Auto Arming
Page 12
Turbo Mode
If this optional Turbo Mode has been programmed at the time of installation,
you can turn this feature on and off by pressing buttons
(III + IV)
for a 1/2 second.
In this mode, if the emergency brake has been set, the engine will continue to run
after the key has been taken out of the ignition. It will run until two minutes after the
emergency brake has been set.
• To utilize this mode, the emergency brake sensing wire has to be connected to the
emergency brake wire of the vehicle. Consult the authorized dealer for this mode.
• This option is ideal for turbo-charged vehicles because it allows the turbo too slowly
cool after operation.
(
2W8000FMR
)
2
nd
Car Mode
This Remote-Pager is able to operate a 2
nd
vehicle.
Press buttons
III & IV
simultaneously for 1/2 second. If this mode is turned to 2
nd
Car,
the Remote-Pager will not communicate with the 1
st
vehicle. To Exit 2
nd
Car press
buttons
III & IV
simultaneously again.
(
2W8000FMR-2
nd
)