Installation guide

Chapter 4. Web Browser-Based Configuration
69
Clone Disk Procedure
(1). Select one of the members as the “Clone Source” (status indicated as Raid Set # )
by clicking on the appropriate check box.
(2). Select a “Clone Target” (status indicated as Free or Hot Spare) by clicking on the
appropriate check box.
(3). If you have available disk member, you can repeat above procedures to define
another clone pair.
(4). Select clone type.
The pair number for both the “Clone Source” and the “Clone Target” will be indicated
in the screen. Click on the “Confirm The Operation” check box and click on the
“Submit” button on the screen; the controller will automatically start the cloning
process using the existing “stand-by” (Free or Hot Spare drive) to clone the source
drive (the Raid Set member drive). The cloning process percentage will be indicated
in the “Volume State” area of the “Volume Set Information” screen. Completion of the
Clone function process will be indicated by a notification message on the event log.
Clone And Replace
You can enlarge your logical drives by copying and replacing all member drives with
drives of higher capacity. The existing data in the logical drives is copied onto the new
drives, and then the original members are marked as “Offlined”.
Clone Only
The stand-by disk will clone the logical drives without substituting it. The status of the
stand-by drive will be marked as “Offlined” after the cloning process. The source drive
will remain a member of the logical drive.