Installation guide

Chapter 4. Web Browser-Based Configuration
67
4
4
4
.
.
.
7
7
7
P
P
P
h
h
h
y
y
y
s
s
s
i
i
i
c
c
c
a
a
a
l
l
l
D
D
D
r
r
r
i
i
i
v
v
v
e
e
e
Choose this option from the Main Menu to select a physical disk and to perform the
operations listed below.
4.7.1 Create Pass-Through Disk
To create pass-through disk, move the mouse cursor to the main menu and click on
the “Create Pass-Through” link. The relative setting function screen appears. A
pass-through disk is not controlled by the RAID subsystem firmware; it can not be a
part of a volume set. The disk is available to the operating system as an individual
disk. It is typically used on a system where the operating system is on a disk not
controlled by the RAID firmware. The user can also select the Cache Mode, Tagged
Command Queuing, SCSI Channel/SCSI ID/SCSI LUN for this pass-through disk.
4.7.2 Modify Pass-Through Disk
Use this option to modify the pass-through disk attribute. The user can modify the
Cache Mode, Tagged Command Queuing, and SCSI Channel/SCSI ID/SCSI LUN on
an existing pass-through disk. To modify the pass-through drive attribute from the
pass-through drive pool, move the mouse cursor bar and click on the “Modify a
Pass-Through” link. The “Select the Pass Through Disk for Modification” screen
appears mark the check box for the pass-through disk from the pass-through drive
pool and click on the “Submit” button to select drive. When the “Enter Pass-Through
Disk Attribute” screen appears, modify the drive attribute values, as you want. After
you complete the selection, mark the check box for “Confirm The Operation” and
click on the “Submit” button to complete the selection action.