Installation guide

Chapter 4. Web Browser-Based Configuration

parameters to “Scheduler” to change the scheduled run time. The “Checking After

System Idle” is defined the default time to start the automated consistency check

scheduling.

Scheduler option: set to 1 week ~ 24 weeks will start volume check after 1 week ~ 24

weeks,

Checking After System Idle option: set to 1 Minute ~ 60 Minutes, when RAID

system idle 1 Minute ~60 Minutes RAID system will start volume check, if host

accesses RAID system that will stop volume check. Next time, when RAID system is

idle for 1 Minute ~ 60 Minutes, RAID system will continue volume check.

Scrub Bad Block If Bad Block Is Found, Assume Parity Data Is Good option:

check button will be shown when Data disk found bad block, and if selected, RAID

controller will regenerate data from Parity disk to data disk, if check button is not

selected RAID controller will report error only.

Re-compute Parity If Parity Error Is Found, Assume Data Is Good option: check

button will be shown when Parity Data disk found bad block, and if selected, RAID

controller will regenerate data from Data disk to Parity Data disk, if check button is not

selected RAID controller will report error only.

Note

Please make sure of the inconsistency source generated by parity

error or bad block before you click the recovery method. Otherwise,

you will lose the recovery data.