Installation guide

Software Operation Manual
98
Such as: Windows 2003 with SP1 or later,
Linux kernel 2.6.x or later
4K Block:
It change the sector size from default 512 bytes to 4k bytes. The maximum volume
capacity up to 16TB. This option works under Windows platform only. And it can
not be converted to “Dynamic Disk”, because 4k sector size is not a standard
format.
A single volume set is created and consumes all or a portion of the disk capacity
available in this RAID set. Define the capacity of volume set in the “Available
Capacity” popup. The default value for the volume set, which is 100% of the
available capacity, is displayed in the selected capacity. use the UP and DOWN
arrow key to set capacity of the volume set and press Enter key to accept this
value. If the volume set uses only part of the RAID set capacity, you can use the
“Create Volume Set” option in the main menu to define additional volume sets.
Stripe Size This parameter sets the size of the stripe written to each disk in a
RAID 0, 1, 10(1E), 5, or 6 logical drive. You can set the stripe size to 4KB, 8KB,
16KB, 32KB, 64KB, 128KB, 256KB, 512KB or 1024KB.
Note
Roaming the stripe size 256K/512K/1024K Raid Set to firmware version
older than 1.52 will cause data corruption.