Installation guide

Software Operation Manual

idle for 1 Minute ~ 60 Minutes, RAID system will continue volume check.

Scrub Bad Block If Bad Block Is Found, Assume Parity Data Is Good option:

check button will be shown when Data disk found bad block, and if selected, RAID

controller will regenerate data from Parity disk to data disk, if check button is not

selected RAID controller will report error only.

Re-compute Parity If Parity Error Is Found, Assume Data Is Good option: check

button will be shown when Parity Data disk found bad block, and if selected, RAID

controller will regenerate data from Data disk to Parity Data disk, if check button is not

selected RAID controller will report error only.

Note

Please make sure of the inconsistency source generated by parity

error or bad block before you click the recovery method. Otherwise,

you will lose the recovery data.

4.6.7 Stop Volume Set Check

Use this option to stop the Check Volume Set function.