Installation guide

Software Operation Manual

disk. It is typically used on a system where the operating system is on a disk and

not controlled by the RAID subsystem firmware.

Using UP/DOWN buttons to choose the “Create Pass-Through Disk” option and

press ENT. Using UP/DOWN buttons to select the drive SAS/SATA number that

user wants to create. The drive attributes will be displayed.

The attributes for Pass-Through disk show the Volume Cache Mode, SAS Port/

SAS LUN Base/SAS LUN, Fibre Port/Fibre LUN Base/Fibre LUN, and Tagged

Queuing.

All values can be changed by user. Press the UP/DOWN buttons to attribute

and then press ENT to modify the default value. Using the up and down arrow

buttons to select attribute value and press ENT to accept the selection value.

3.7.4.3 Modify Pass-Through Disk

To modify Pass-Through Disk attributes from Pass Through drive pool, press

UP/DOWN buttons to choose the “Modify Pass-Through Disk” option, and then

press ENT. The select drive function menu will show all Pass Through disk

number items. Using UP/DOWN buttons to select the Pass-Through Disk that

user wants to modify and press ENT. The attributes screen shows the Pass

-Through Disk setting value that was currently being configured

The attributes for Pass-Through Disk are the Volume Cache Mode, Tagged

Command Queuing and SAS Port/ SAS LUN Base/SAS LUN, Fibre Port/Fibre

LUN Base/Fibre LUN. All value can be modified by user. Press UP/DOWN

buttons to select attribute. Press ENT to modify the default value. Using the up

and down arrow buttons to select attribute value and press ENT to accept the

selection value. After completing the modification, press ESC to enter the

confirmation screen and then press ENT to accept the “Modify Pass-Through

Disk” function.

3.7.4.4 Delete Pass-Through Disk

To delete pass-through disk from the pass-through drive pool, press UP/DOWN

buttons to choose the “Delete Pass-Through Disk” option, and then press ENT.

The Select Drive Function menu will show all pass-through disk number items.

Using UP/DOWN buttons to select the pass-through disk that user want to

delete and press ENT. The delete pass-through confirmation screen will appear,

Press ENT to delete it.

3.7.4.5 Identify the Selected Drive

To prevent removing the wrong drive, the selected disk Fault LED indicator will

light for physically locating the selected disk when the “Identify the Selected

Drive” function is selected.

To identify selected drive from the physical drive pool, press UP/DOWN buttons

to choose the “Identify the Selected Drive” option, and then press ENT key. The

Select Drive function menu will show all physical drive number items. Using

UP/DOWN buttons to select the disk that user want to identify and press ENT.