Installation guide

Software Operation Manual
20
2
2
2
.
.
.
2
2
2
U
U
U
s
s
s
i
i
i
n
n
n
g
g
g
l
l
l
o
o
o
c
c
c
a
a
a
l
l
l
f
f
f
r
r
r
o
o
o
n
n
n
t
t
t
p
p
p
a
a
a
n
n
n
e
e
e
l
l
l
t
t
t
o
o
o
u
u
u
c
c
c
h
h
h
-
-
-
c
c
c
o
o
o
n
n
n
t
t
t
r
r
r
o
o
o
l
l
l
k
k
k
e
e
e
y
y
y
p
p
p
a
a
a
d
d
d
The front panel keypad and liquid crystal display (LCD) is the primary user
interface for the RAID subsystem. All configuration and management of the
RAID and its properly connected disk arrays can be performed from this
interface.
The front panel keypad and LCD are connected to the RAID subsystem to
access the built-in configuration and administration utility that resides in the
controller’s firmware. Complete control and management of the array’s physical
drives and logical units can be performed from the front panel, requiring no
additional hardware or software drivers for that purpose.
This Chapter provides, in quick reference form, procedures that use the built-in
LCD panel to configure and operate the controller.
A touch-control keypad and a liquid crystal display (LCD) mounted on the front
panel of the RAID subsystem is the primary operational interface and monitor
display for the disk array controller. This user interface controls all configuration
and management functions for the RAID subsystem controller and for all SAS
/SATA disk array subsystems to which it is properly connected.
The LCD provides a system of screens with areas for information, status
indication, or menus. The LCD screen displays up to two lines at a time of menu
items or other information.
The Initial screen is as following: