Installation guide

Software Operation Manual
110
5.5.2.4 Offline Raid Set
This function is for customer being able to unmount and remount a multi-disk
volume. All Hdds of the selected RAID set will be put into offline state and spun
down and fault LED will be in fast blinking mode.
5.5.2.5 Activate Incomplete Raid Set
The following screen is used to activate the RAID set after one of its disk drive
was removed in the power off state.
When one of the disk drives is removed in power off state, the RAID set state will
change to “Incomplete State”. If user wants to continue to work while the RAID
subsystem is powered on, the user can use the “Activate Incomplete Raid Set”
option to active the RAID set. After user selects this function, the RAID state will
change to “Degraded Mode” and start to work.