User's Guide
Table Of Contents
Installaon
The mounng hook is very difficult to relocate aer being affixed to the mounng surface. Test
your locaon before affixing the mounng hook to the surface. Use masking or painters sensor
tape to secure the mounng hook to the surface. Once you have the mounng hook temporarily
mounted then hang the sensor on the hook, test out the sensor. With the app in hand, follow the
Device Alerts secon on page to test water warning and warning removed using the app and 17
observing the status of the sensor as shown on the app (Water Warning or Water Warning
Removed). Oponally, you may set up your automaon (e.g. turn off a valve when water is
detected) to funconally test the alert of the sensor - proceed to the following steps for
informaon on creang automaons, then return to this step
Test the Sensor Locaon Before Installaon
This sensor is not waterproof and is designed and intended only for indoor use. Subjecng this
device to outdoor environment condions such as direct sunlight, extreme hot or cold
temperatures, rain, water and/or condensaon can damage the device and will void the warranty
If flooding is a risk mount the sensor at a higher locaon, where it is less likely to get wet (which
may render it non-funconal)
Please refer to device environmental operaon range on page 30. Use this device outside the
recommended ranges at your own risk
7
Avoid allowing the Water Leak Sensor 2 to be exposed to strong impacts or vibraon
Please add the Water Leak Sensor 2 to the YoLink app before installaon