User's Guide
Table Of Contents
About YoLink Control
YoLink Control is our unique device-to-device control technology. Using YoLink Control, YoLink
devices can be controlled without the Hub or an internet connecon. (Use of YoLink Control is
oponal; you can use the Automaon feature in the app OR use YoLink Control, but YoLink
Control offers the benefit of operaon without the Hub or internet connecon.)
One device controls another, directly. A device that sends out commands is called the controller. A
device that receives the commands is called the responder. Examples of a controller are a Water
Leak Sensor, while examples of a responder are a Siren or a Gas/Water Valve (Controller)
To configure your Water Leak Sensor 2 as a controller, press and hold the SET buon for 5-10
seconds unl the LED quickly blinks green
Upon pairing, the LED will stop blinking (this may happen aer only blinking two or three mes)
To configure a Valve as the responder, ensure the Valve Gas/Water Controller Gas/Water
Controller Gas/Water Valve Controller manual) (refer to has already been bound to the YoLink
app. Using the app, close the valve (verify the valve is shown to be Closed on the app, or press
the Close buon if it is shown as Open). Press and hold the SET buon for 5-10 seconds unl
the LED quickly blinks green
Pairing
The Water Leak Sensor 2 can only work as the controller in YoLink Control
23