User's Guide

Garage Door Controller
Locate the 2 power terminals at the left of the controller. You will see “5V+”and “5V-” on
it. Find your adapter and put the red wire of it in the “5V+” terminal. Put the black wire in
the “5V-” terminal. Now there are 2 terminals named “signal” to be connected. First,
put two wires in these two terminals.
Locate the 2 terminals on the back of your garage opener that your button panel wires
connect to. Take out the existing button panel wires from the opener, twist it with one
fro m the c onne cter. Then put the twi sted wire b ack in the terminal of the op ener.
Repeat the steps to the other wire. It doesn't matter which wire goes to which terminal.
Installation
Note
Please add Garage Door Controller and Sensor to YoLink App before you set them up.
Wiring diagram is shown the next page.
You can also connect your controller with your button panel. You will just to do the same
thing as it is in step 2.
10