User's Guide

E. About Garage Door Control With Fobs (Physical Buon
Control, Only)
Pair your YoLink Fob with the YS4906-UC Garage
Door Controller or YS4908-UC YoLink Finger.
Wh en yo u press the associ ated buon, the
YoLink Finger will operate (it will open or close,
depending on the current status of the door)
E-1-1. Pairing
Choose the fob buon you will use
for control of the Garage Door
Controller. Hold this buon for
5-10 seconds unl the LED quickly
blinks green. Then, release the
buon
1
E-1. Pair YoLink Fob with YS4906-UC
Garage Door Controller
Press and hold the SET buon on the YoLink
Finger for 5-10 seconds unl the LED quickly
blinks green. Then, release the buon
2
Upon pairing, the LED will stop blinking
(this may happen aer only blinking two or
three mes)
3
b. SET buon
(5-10 seconds)
a. Any of the four
buons
(5-10 seconds)
H o l d i n g t h e
b u  o n l o n g e r
than 10 seconds
will ABORT the
pairing operaon
15
Yo u c a n a ssig n a s cene or a u tomao n
assigned to any of the four buons in the
ap p , b ut y ou ca n n o t a d d t h e ga rag e
controller as an acon. This is for safety
reasons, to prevent accidental operaon of
the door