User Guide

Chapter 4 - Installation Notes 25
You must load NWASPI.CDM for both SCSI and fibre channel devices. Refer to the appropriate section
below to configure NWASPI.CDM for single or multiple LUNs.
Single LUN Devices
For Yosemite Backup to “see” your single LUN devices, you must load NWASPI.CDM. However, single
LUN devices do not require any LUN support.
1. Add the following line to the STARTUP.NCF file:
load NWASPI.CDM
NOTE: Add this line above all HAM drivers in the STARTUP.NCF file. Otherwise, NetWare will not
load the HAM drivers.
2. Restart the NetWare server and load Yosemite Backup.
3. Access the Device page to verify that the device appears.
Multiple LUN Devices
WARNING: The command and procedures to enable multiple LUNs on SCSI adapters vary. Always
consult the manufacturer's documentation for the correct command for your device. The following
example serves as a guide to illustrate the process.
For Yosemite Backup to “see” your multiple LUN devices, you must load NWASPI.CDM and enable
LUN support for the device.
1. Add the correct line for your device to the STARTUP.NCF file. For example:
load NWASPI.CDM /LUN
NOTE: This line should be added above all HAM drivers in the STARTUP.NCF file. Otherwise,
NetWare will not load the HAM drivers.
2. If a similar line already exists, make sure it includes the /LUN option if appropriate for your device.
3. Locate the HAM driver for your device in the STARTUP.NCF file. For example, the following line
appears for an Adaptec 29160 SCSI card:
load ADPT160M.HAM
4. Add lun_enable=ff to the end of driver line. For example, to enable LUN support for an
Adaptec 29160 SCSI card, the new line would be:
load ADPT160M.HAM lun_enable=ff
Consult your manufacturer's documentation for the correct statement.
5. Restart the NetWare server and load Yosemite Backup.
6. Access the Device view to verify that the device appears.