Technical data

Table of Contents
1 SUPPLIER INFORMATION
1.1 Introduction 1.1
1.2 Warranty 1.1
1.3 Safety 1.1
1.4 Responsibility for Safety 1.1
1.5 About this Manual 1.2
1.6 Misuse of Equipment 1.2
1.7 Safety Labels 1.3
1.8 Material Safety Data 1.4
2 Product Description
2.1 General 2.1
2.2 Capacity Control 2.2
2.3 Compressor 2.3
2.4 Compressor Lubrication System 2.3
2.4.1 Oil Pump
2.4.2 Oil Heater
2.5 Compress Motor 2.5
2.6 Graphic Control Centre 2.5
2.7 Heat Exchangers 2.6
2.7.1 Evaporator
2.7.2 Condenser
2.7.3 Water Boxes
2.8 Refrigerant Flow Control 2.6
2.9 Options and Accessories 2.7
2.9.1 Service Isolation Valves
2.9.2 Hot Gas Bypass
2.9.3 Solid State Starter
2.9.4 Variable Speed Drive
2.10 Nomenclature 2.8
2.11 Range of Models 2.8
3 TRANSPORTATION, RIGGING AND
STORAGE
3.1 General 3.1
3.2 Shipment 3.1
3.3 Inspection, Damage and Shortage 3.2
3.4 Rigging 3.3
4 INSTALLATION
4.1 Location 4.1
4.2 Motors 4.1
4.3 Foundation 4.1
4.4 Clearances 4.1
4.5 Rigging Unit to Final Location 4.1
4.6 Locating and Installing Isolator Pads 4.1
4.7 Installing Optional Spring Isolators 4.2
4.8 Piping Connections 4.2
4.9 Cooler and Condenser Water Piping 4.2
4.9.1 Condenser Water Circuit
4.10 Stop Valves 4.6
4.11 Flow Switches (Field Installed) 4.6
4.12 Drain and Vent Valves 4.6
4.13 Checking Piping Circuits and Venting Air 4.6
4.14 Refrigerant Relief Piping 4.6
4.15 Unit Piping 4.6
4.16 Control Panel Positioning 4.7
4.17 Control Wiring 4.7
4.18 Power Wiring 4.7
4.19 Units with Solid State Starter
or Variable Speed Drive 4.8
4.20 Thermal Insulation 4.8
4.21 Installation Check 4.8
035L02381-GB0 I-i