Specifications

2 YORK INTERNATIONAL
This equipment is a relatively complicated apparatus.
During installation, operation, maintenance or service,
individuals may be exposed to certain components or
conditions including, but not limited to: refrigerants, oils,
materials under pressure, rotating components, and both
high and low voltage. Each of these items has the po-
tential, if misused or handled improperly, to cause bodily
injury or death. It is the obligation and responsibility of
operating/service personnel to identify and recognize
these inherent hazards, protect themselves, and proceed
safely in completing their tasks. Failure to comply with
any of these requirements could result in serious dam-
age to the equipment and the property in which it is
IMPORTANT!
READ BEFORE PROCEEDING!
GENERAL SAFETY GUIDELINES
situated, as well as severe personal injury or death to
themselves and people at the site.
This document is intended for use by owner-authorized
operating/service personnel. It is expected that this indi-
vidual possesses independent training that will enable
them to perform their assigned tasks properly and safely.
It is essential that, prior to performing any task on this
equipment, this individual shall have read and understood
this document and any referenced materials. This indi-
vidual shall also be familiar with and comply with all
applicable governmental standards and regulations per-
taining to the task in question.
SAFETY SYMBOLS
The following symbols are used in this document to alert the reader to areas of potential hazard:
CAUTION identifies a hazard which
could lead to damage to the machine,
damage to other equipment and/or en-
vironmental pollution. Usually an in-
struction will be given, together with
a brief explanation.
NOTE is used to highlight additional
information which may be helpful to
you.
CHANGEABILITY OF THIS DOCUMENT
In complying with YORK’s policy for continuous prod-
uct improvement, the information contained in this
document is subject to change without notice. While
YORK makes no commitment to update or provide
current information automatically to the manual owner,
that information, if applicable, can be obtained by con-
tacting the nearest YORK Applied Systems Service
office.
It is the responsibility of operating/service personnel
as to the applicability of these documents to the equip-
ment in question. If there is any question in the mind
of operating/service personnel as to the applicability
of these documents, then, prior to working on the equip-
ment, they should verify with the owner whether the
equipment has been modified and if current literature
is available.