User`s guide

ADDITIONAL PROGRAMMING INFORMATION
1. The [LED] button will illuminate while the remote is in a programming mode. In the absence of a
keypress entry, the [LED] button will stop illuminating after 30 seconds and the remote will exit
the programming mode.
2. The Point and Press® (Auto-Scan) Programming method allows you to
program your remote
control
without using codes. Instead, the remote control automatically finds the correct TV setup
code using certain buttons/commands that you select. Once you have found a setup code that
operates your TV, you then lock it in.
3. When using the Point and Press® Programming Method, there are several important points to
remember:
• There may be several codes that turn your TV on/off (or perform other functions)
• It may take several minutes for the remote to find the correct code that turns your TV
on/off (or performs another selected function). During this time, the [LED] button will
illuminate.
4. When programming the remote control using the [∆] or [∇] buttons (Power function) under the
Point and Press® Programming method, you may find a code that turns your TV off but not back
on. If this happens…
• The correct TV code has not been found, you may have a code that operates some but
not all of the functions of your TV. Continue pressing [∆] until your TV turns back on.
Or
• You may have gone past the correct matching code. Try pressing [∇]
one press at a time
until you find a code that turns your TV back on.
5. When using the Point and Press® Programming method, you can also program your remote
using the following buttons:
• [VOL ∆]- to “go forward” through the codes using the “VOL ∆” function on your TV.
• [VOL∇]- to “go back” through the codes using the “VOL∇” function on your TV.
Note: When you find the correct code, the volume of the TV being programmed will increase
or decrease.
FCC Warning: This device complies with Part 15 of the FCC Rules. Changes or modifications to this
device not expressly approved by the parties responsible for compliance could void the user’s authority
to operate this remote control
Rev. 0906
© 2006, Contec Holdings, LLC
Point and Press® and Memory Guard® are registered trademarks of the Contec Holdings, LLC
MOTOROLA and the stylized M logo are registered in the U.S. Patent and Trademark office
Page 7