User`s guide
2. If the TV does not turn back on, enter a different three-digit setup code until your TV turns
back on. Then press [SELECT] to lock in the code. The [LED] button will blink three-times
and go out.
Point and Press ® (Auto-Scan) TV Programming using your SRC-350 keypad:
This method allows you to program your remote control
without codes using the [∆] or [∇] buttons
(“Power” function during programming). For more information on this method as well as other buttons
you can program your remote with, see Section 9.
1. Turn on your TV
2. In this order, press and hold the [SELECT] button, then the [MUTE] button. Hold
both buttons
down
together until the [LED] button illuminates. Release both buttons as soon as the [LED] button
illuminates.
3. Press [∆]
one step at a time until your TV turns off. Each time you press the [∆] button, the [LED]
button will blink. As soon as your TV turns off, stop pressing the [∆] button.
4. Press [MUTE]. If your TV…
a. Turns back on, press [SELECT] to lock in this code. The [LED] button will blink three-
times and go out
Or
b. Does not turn back on, press the [∇] button
one step at a time until your TV turns back on.
Each time you press the [∇] button, the [LED] button will blink and remain illuminated.
Once you have found a code that turns the decide on/off, press [SELECT] to lock in this code. The
[LED] button will blink three-times and go out.
Note: Given the size of the TV Setup Code library in your remote control, it will take several minutes to
cycle through all the codes when using the Point and Press Programming method.
TV CODE NUMBER READBACK
To identify the three-digit TV Setup Code stored under the Point and Press® programming method,
follow these steps using the remote control keypad…
1. In this order, press and hold the [SELECT] button, then the [MUTE] button. Hold
both buttons
down
together until the [LED] button illuminates. Release both buttons as soon as the [LED]
button illuminates.
2. Press [INFO], then [C]. The [LED] button will “blink back” the code numbers, with a 1-second
interval between each digit of the code. Please note that for the numeric [0], the [LED] button will
blink in fast-sequence.
Example: For TV Setup Code “130”, the remote will blink 1 time, then 3 times, then in a fast-
sequence for the 0.
Page 6