User`s guide

Programming the Remote Control ID using your SRC-350 keypad:

1. In this order, press and hold the [SELECT] button, then the [MUTE] button. Hold

both buttons

down

together until the [LED] button illuminates. Release both buttons as soon as the [LED]

button illuminates.

2. Press and release the [A] key. The [LED] button temporarily turns off. Releasing the key causes

the [LED] button to light up again. You can now set the correct Remote Control ID.

3. Enter the single-digit Remote Control ID from the table above. The LED button will blink three-

times and go out. The new Remote Control ID is stored in the device.

Note: Valid single-digit codes are 0,1,2, or 3. If you entered an invalid sequence or a 30-second lapse

between button presses occurs, the [LED] button illuminates. Release both buttons as soon as the [LED]

button illuminates.

LED Playback of the Remote Control ID:

1. In this order, press and hold the [SELECT] button, then the [MUTE] button. Hold

both buttons

down

together until the [LED] button illuminates. Release both buttons as soon as the [LED]

button illuminates.

2. Press [INFO], then [A]. The [LED] button will “blink back” the Remote Control ID. Please note that

for the numeric [0], the [LED] button will blink in fast-sequence.

PROGRAMMING YOUR TV

Your Network Service Provider programs your remote control to work with your TV by way of a TV Setup

Code. The TV Setup Code is a specific code for each brand and model of TV. When a TV Setup Code is

set, the remote control is ready to operate the TV. The TV Setup Codes can be programmed manually,

or they can be auto-scanned. Each method is described below.

Code-Entry (Manual) TV Programming using your SRC-350 keypad:

1. Turn on your TV

2. In this order, press and hold the [SELECT] button, then the [MUTE] button. Hold

both buttons

down

together until the [LED] button illuminates. Release both buttons as soon as the [LED]

button illuminates.

3. a. Locate the three-digit code for your brand in the TV Setup Code list (Section 11) and enter it on

the keypad of the remote control. Entry of the correct code will cause your TV to turn off. If

multiple codes are listed for your brand, you may have to ender several different codes until your

TV turns off.

b. As soon as you have entered a three-digit code that turns you TV off, press [MUTE].

1. If the TV turns back on, press [SELECT] to lock in the code. The [LED] button will blink

three-times and go out.

Page 5