Owner`s manual

24
ENGLISH
EMERGENCY OPERATIONS
This function is used to operate the unit temporarily in
case you misplace the remote controller or its batteries
are exhausted.
Two modes including AUTO and mandatory COOL can
be selected through the EMERGENCY BUTTON on the
air inlet grill control box of the indoor unit. Once you push
this button, the air conditioner will run in such order:
AUTO, mandatory COOL, OFF, and back to AUTO.
1. AUTO
The RUN lamp is lit, and the air conditioner will run
under AUTO mode. The remote controller operation is
enabled to operate according to the received signal.
2. Mandatory COOL
The RUN lamp flashes, the air conditioner will turn to
AUTO after it is enforced to cool with a wind speed of
HIGH for 30 minutes. The remote controller operation
is disabled.
3. OFF
The RUN lamp goes off. The air conditioner is OFF
while the remote controller operation is enabled.
EMERGENCY
BUTTON
MAINTENANCE
Before you clean the air conditioner, be sure to disconnect the power supply plug.
• Use a dry cloth to wipe the indoor unit and remote controller.
• A cloth dampened with cold water may be used on the indoor unit if it is very dirty.
• Never use a damp cloth on the remote controller.
• Do not use a chemically-treated duster for wiping or leave such material on the unit for long, because it may
damage or fade the surface of the unit.
• Do not use benzine, thinner, polishing powder, or similar solvents for cleaning. These may cause the plastic surface
to crack or deform.
If you do not plan to use the unit for at least 1 month.
(1) Operate the fan for about half a day to dry the inside of the unit.
(2) Stop the air conditioner and disconnect power.
(3) Remove the batteries from the remote controller.
WARNING
Cleaning the indoor unit and remote controller
J391_EN.indd 24 3/14/07 1:34:20 PM