User manual

Antwerpsesteenweg 19 - 9080 Lochristi - Belgium - www.racktivity.com v 2014.5.14

Reconfigure EnergySwitches

Whenever new modules like Energy sensor have been added to the

EnergySwitch, these modules can be integrated in the DCPM via a

reconfiguration of the ES. This way you are not losing any historical

data.

Vice versa, in case an Energy sensor is disconnected from the

EnergySwitch, a reconfiguration will delete the data from DCP.

To reconfigure the energy switch you need to go to the energy switch

in DCPM and press the Reconfigure Energy Switch under the action

button.

When pressing the reconfiguration button DCPM will perform 4 steps

- Scanning for hardware changes

- Discover changes

- Reconfiguring Energy Switch

- Set up SNMP trap receivers

Edit Energy Switch

DCPM allows the user to edit the Energy switches that are installed. To

edit the energy switch you need to go to the energy switch in DCPM and

press the “Edit Energy Switch” under the action button.

Pressing this button will open a new window containing several

bookmarks:

 Edit energy Switch

 Configure

 Lines

 Additional Parameters

Edit Energy switch

Under this section DCPM allows the user to:

 Change the device name

 Add a power feed to the device

 Add Tags (used for Formulas)

 Add labels

Configure the Energy Switch

Under this section DCPM allows the user to:

 Change the device IP address

 Change the port

 Update account information for admin and guest user.